Page 1 of 1

updating Ubi code manually

PostPosted: Mon Jul 24, 2017 9:53 pm
by Setsuzoh
I haven't plugged in my ubi for a long time. After dusting off the ubi and plugging it in and going through the setup steps. The Ubi cannot detect any wireless networks after many retries.

Assuming there has been some code updates to Ubi since i last used.

Is there a method to upload any code updates to Ubi manually, when not connected to the internet?

Thanks in advance.

Re: updating Ubi code manually

PostPosted: Mon Sep 18, 2017 4:45 am
by notgreg
Hi there,

Unfortunately, there is no offline code update method that I know of. It's always pushed out from the Internet.

A few things to try:

1. Make sure the SSID of your 2.4GHz network is unique
2. Make sure you do not have MAC address security turned on.
3. Make sure you have enough DHCP leases/free IP addresses on your network

The other usual wifi caveats also apply. Bring it closer to the router, check for wifi interference from other networks etc.